Plastic Circumstance Step 3 Masque Sealant 1000ml: It promotes the maximum hydration of the threads reducing the frizz and accentuating the smooth effect. Products are not available individually.
Plastic Hairband Primer Leave-in 110ml: prepares hair for modeling and fights frizz. Treatment consisting of Arginine, Acai Extract and Acetic Acid (pH acid). Acai extract: rich in nutrients such as vitamins, essential sugars and emollient oils. Its antioxidant and protective action promotes a complete regeneration of the threads, hydrating them in an efficient and prolonged way. Amino acids: balance the structure of the yarns of aggressions caused by the excessive use of dryers and plungers. Increases suppleness and elasticity, making hair softer and easier to comb. Phytonutrients: Nourish and protect wires, helping to regenerate damaged and worn parts. Shampoo with Acetic Acid: because it is acidic, it can cause irritation and scaling on the sensitized leather. For this reason we recommend not to apply in pregnant women, people with sensitive skin and children up to 12 years. UV filter (leave-in): protects the wires from solar damage while preserving the integrity of the wires and leaving them soft and smooth. Note: It offers about 35 applications. Micro Quality Labs (USA) and Anvisa.The effect is prolonged with the use of the Caddyu Plastic Cord maintenance products. It should not be applied in pregnant women, people with sensitive scalp and children.
Try BRUSH PLASTIC BRUSH 3x1L + PRIMER LEAVE-IN 110ml and see results. Material Needed: Silicone gloves, dryer, plank, plastic tabs, thin comb, brush and plastic container.
1- Wash the hair with the Pre-Treatment Shampoo, massaging until it forms foam. Wash twice in case of virgin hair, very resistant or very dirty.
Leave on for 5 minutes and rinse thoroughly. Attention: do not rub the scalp. 2- Dry the hair in 80% with the dryer and help of the fingers. 3 - Separate the hair in 6 parts (a vertical line separating the hair in two rows - right and left - and 3 horizontal sessions - nape, middle and front from the ears).
Hold each session in a bun with a loop. 4- Pour 20 to 40ml of the Thermal Seal into a container and put on the silicone gloves. 5- Start applying a wick on the back of the neck with the aid of a brush.Apply two fingers of the root at the base of the wick and pull the product up to the tips with the comb. Make sure the product is on all wires.
6- Repeat the procedure with the side wick. 7- With the dryer in the cold jet, dry the two wicks in 100%. It is important to dry two wicks at a time with the cold jet. This avoids the formation of smoke and prevents the product from evaporating without effect. 8- Repeat the procedure from 5 to 7 in the two central hair strands, one at a time.9- Finally, repeat procedure 5 to 7 on the two front hair strands, drying the strands back. It is important that neither the dryer wind nor the wick with the product come in contact with the face.
In blond hair, damaged or chemically the temperature of the board should not exceed 200 ° C. In normal, virgin or temperature resistant hair it should be at 230 ° C. 11- Divide hair back into parts using loops. Separate a thin, linear wick and draw the length (without the tips) of the wick 10 times (plank at 200 ° C) or 7 times (plank at 230 ° C). 12- Practice the tips (without the length) of the hair up to 4 times (plank at 200 ° C) or 2 times (board at 230 ° C).This way you avoid the artificial smooth effect on the tips. 13- Repeat this process (step 11 and 12) through all strands of hair. The flat iron in relation to the leather leaves the wires smoother naturally from the root. 14- After boarding all the strands. 15- Apply the Restorative Mask on the threads by gently massaging the wicks.
Leave on for 5 minutes and rinse again. 16- Dry the hair with the dryer. Note: In the case of relaxed or smoothed hair, apply the plastic thermal sealing of the threads after the chemical process. In case of dyeing or toning, apply the Plastic Thermal Sealing of the Wire two days before or after dyeing, to better fix the pigments of the color in the threads. Cadiveu recommends that you use this treatment with the help of a professional.
Apply a small amount of Plastic Leave-in Primer Yarn on washed and damp hair, shaping as desired. Can be used before the dryer, plank, or modeler.
If you prefer, you can also let it dry naturally. Tip: For best results, use the rest of the Yarn Plastic line together. Naturally smooth, frizz-free, stronger, repaired hair with incredible shine for up to 3 months!
Orders outside the United States. (Boxes, packaging, instructions, ETC) Everything we send needs to come back.
No physical damage will be accepted!!! This item is in the category "Health & Beauty\Hair Care & Styling\Relaxers & Straightening Prod".The seller is "fridarafa" and is located in this country: BR. This item can be shipped worldwide.